Hot Air Machine
It is also known as SMD Hot Air Rework Station. It is used to Sold and Desold Chip components such as SMD IC, BGA IC etc. We can also adjust air pressure and temperature according to the requirement. There are two knobs for the purpose.
25 Watt Iron
It is used to sold or desold electronic parts and components. It is operated on AC Voltage.
Solder wire
It is used to soldering of various electroinic components on PCB. Solder wire melts by the iron and we can apply this melt solder wire wherever required.
Solding paste/Flux
It is used to do fine solding.
Forchef
It is used to pick and place various electronic components while working on PCB.
Toolkit
It is used to open various types of screws. It has many pieces.
ISO Propyl Alcohal
To clean PCB, this solution is used, if there is a dirt or carbon on PCB. It is also used to clean various contact points such as mike, speaker, vibtrator contact points when there is carbon or dirt on there.
Iron Stand
Iron stand is used to hold the iron.
Desolding Wire
By using this we can remove extra/unwanted solder from the PCB
Multi Meter
It has many uses, that is why it is known as multimeter. General uses are checking various electronic components, DC Volt Checking, AC Volt Checking, Checking DC Current and AC Current.
Desoldering Pump
It is used to remove extra solder from PCB. It automatically sucks extra solder.
Blower
It is used to remove dust from the motherboard and cabinet
Logic Probe
It is used check digital logic on motherboard's various places. It shows logic 0,1 or pulsating.
Wire Cutter
It is used to cut and strip the wire.
Osciloscope
To check various signal on motherboard it is used.
